Vijay Maruti Print Pack Machineries

Technical parameter requirement:

n  Model  MC150-1800 

n  Total length  About 95 meters  (depend on base drawing)

n  Design speed  150 m/min 

n  Working speed  60-90 MPM for 5-ply board, 70-120 MPM for 3-ply board 

n  Effective width  1800mm

n  Flute: A / C / B / E for choice

n  Steam pressure and consumption
Pressure 1.0 - 1.2MP    Consumption about 2500-3500kg/h

n  Air pressure and consumption
Pressure0.8 - 1.0 MPa    Consumption about: 1.5 m³/min

n  Slitting precision: ±1mm

n  Cutting length and precision  500 - 9999mm, ±1mm

n  Total power about +/- 220KW (380V, 50HZ), Working power required: +/- 150KW

n  Dimension  about 95m×10m×5.2 m (L×W×H)

II. Electric parts and pneumatic parts brand:

n  Electric parts brand: Schneider, Chint, Siemense, CPG, Autonics, Delta, Omron 

n  Pneumatic parts brand: Zhe jiang CSM, Airtac 

III. Test basis paper for production line should meet follow requirements;

n  Machine surface temperature: not less than 175℃ 

n  Basis paper scale ≥B 

n  Basis paper moisture: 8%-10%
liner: 100 - 180 g/m2 (N.m/g ≥ 8);
medium paper: 80 - 160 g/m2 (N.m/g ≥ 5.5);
corrugated paper: 90 - 160 g/m2 (N.m/g ≥ 6);

IV. some parts equipped by consumers 

n  Heating system: one set steam boiler that rate capacity is 4000kg/h, rated pressure 1.25Mpa

n  Install outside steam pipe and air return-air drainage duct to correct position.

n  Compressored air tube, glue pipe, steam pipe and air return pipe have to be installed at correct position before seller’s engineer arrive.

n  Water, electricity, gas installation ground work.

n  Equipment machine grease, lubrication oil, engine oil.

n  Test basis paper, corn(potatoes)starch, caustic soda for industrial use, Borax and other material

n  Before installation, make sure steam pressure reach to 10-12KG and keep heating part surface temperature over 175℃

n  Buyer has to install Main Power cables & switches of each machines by themselves. Buyer shall arrange welding machine & rods, metal cutting machine , grinding wheels etc, crane equipments forklift with operator , masonary work with cement sand stone etc if & when required , 6 to 8 persons to assist for installation.

Characteristics:

1.      PLC control.

2.      Main motor controlled by frequency convertor.

3.      It can feed corrugated sheet automatically at speed of 0-60 pcs/min

Specification: